Are you having an issue with the overhead garage door not moving?
If a garage door abrasion and owners find that their garage doors aren’t closing like when they first purchased them, it can be both an annoying and an expensive problem to fix.
Almost all overhead garage doors are made with steel, so it needs to be replaced when it gets worn.
Luckily, there are a few reasons as to why your garage won’t close, but they can be fixed so you can move on without spending more money than you should. Keep on reading to learn more about garage door repairs.
The Safety Sensors Are Looking Blocked
One of the most common reasons why garage doors won’t close is because the safety sensors are then blocked.
The sensors are usually located at the bottom of the garage door opener, and they emit a beam of infrared light. Once the beam’s interrupted, the door won’t close.
To fix this problem, clear away any debris that may be blocking the sensors. You may also need to adjust the sensors themselves if they’re not pointed in the right direction.
The Tracks Are Dirty or Misaligned
Another common reason for garage door problems is dirty or misaligned tracks. The tracks are the metal strips that the door rolls along as it opens and closes.
If they’re dirty, the door can get stuck. If they’re misaligned, the door may not close all the way.
To fix this problem, clean the tracks with a rag or brush. You may also need to use a screwdriver or hammer to adjust the tracks back into place.
The Springs Seem Broken
Your garage door is broken and is making a loud noise when you try to close it, it’s likely that the springs are broken.
The springs are what help to balance the door, and they’re under a lot of tension. If they break, the door will become very heavy and won’t be able to close.
In that case, you’ll need to replace the springs. This is a job best left to a professional, as it can be dangerous to work with the springs. Click here and get a free estimate.
The Opener Is Defective
In some cases, the problem may be with the opener itself. If the opener is defective, it may not be sending the proper signal to the door to close. This is due to many factors, including a bad motor, a loose wire, or a faulty circuit board.
If you suspect that the opener is the problem, you can try resetting it. If that doesn’t work, you may need to replace the opener.
The Remote Is Defective
If you’re using a remote to open and close your garage door, a defective remote can be the culprit. The remote may not be sending the proper signal to the opener, or the batteries may be dead.
Be sure to check the batteries first if you’re using a remote. If the batteries are good and the remote still isn’t working, you may need to replace the remote.
Here’s Why Your Garage Won’t Close All The Way
If your garage won’t close, there are a few potential reasons why. The most common reasons why it blocks the safety sensors, dirty or misaligned tracks, broken springs, or a defective opener. In some cases, the problem may be with the remote or keypad.
Find this post helpful? Check out the rest of our blog for more insightful content.